PLASTAR® PETG SHEET
Superior impact resistance
Excellent printability, excellent chemical resistance
Excellent light transmittance, superb surface gloss
Does not include harmful material
Easy fabrication (Excellent thermoforming)
Vending machinesVending machines
Properties of PETG
|Specific gravity||ASTM D792||-||1.27||-||1.27|
|Refractive index||ASTM D542||%||0.1||%||0.1|
|Tensile strength||Elongation rate||ASTM D638||Psi||7832||Mpa||54|
|Elongation rate||ASTM D638||%||29||%||29|
|Curve Strength||ASTM D790||Psi||11269||Mpa||77.7|
|Curve Elasticity||ASTM D790||Psi||310381||Mpa||2140|
|Izod impact strength (Notched)||ASTM D256||ft-lb/in||12.0(P)||J/m||642.3(P)|
|Rockwell hardness||ASTM D785||R Scale||122||R Scale||122|
|Load Deformation temperature||ASTM D525||156||℉||69||℃|
|Vicat softening temperature test||ASTM D 525||185||℉||85||℃|
PLASTAR® APET SHEET
Transparency (gloss surface))
Transparent film has high transparency to give good flatness and glossiness.
Used typically as insulation material for electrical parts (connector and adapter etc.) as it has good electric insulation; it also has excellent moisture/water resistance.
One of The best tensile strength & Elongation among the plastic films is PET film – Has few size change in the temperature range 70℃~150℃.
Show stability against most of the chemical agents except strong alkaline agents, chemicals do not get infiltrated.
Does not break compared to glass and acrylic sheets, so it can be down gauged;
remains strong in low temperature under –40℃, can be used in wide ranges from buildings to electronics.
Can be bended without heat; when bending on the back layer with heat, can be bended without chalking two times faster than acrylic bending.
Plasticizer or stabilizer is not required when producing, safe and no harm to the human body.
Poster clear cover
Clear clamshell packaging